HoursMon – Fri 7:30am – 5:00pm

Installation

Fitting a foot clamp correctly.

Updated 15 Nov 2026 · installationfoot-clamps

This page shows the doc layout: breadcrumbs, an "On this page" table of contents, code blocks, callouts and previous/next links.

Before you start

Check that you have the right clamp for your rod size.

Rod Clamp Teeth
NQ FC-N T-N4
HQ FC-H T-H4
PQ FC-P T-P4

Fitting

  1. Isolate the rig.
  2. Remove the old teeth.
  3. Fit the new holder and torque to spec.
torque: 180 Nm
thread: M20 x 2.5
Warning Always isolate the rig before working on the clamp.

Checking alignment

Close the clamp on a test rod and check that all teeth make even contact.

Next steps

Read the guides for maintenance intervals.